Hi, friend Welcome to my store Please contact me if you have any questions. KTC-75 100 125 150 175 200 250 250 275mm Linear displacement transducer [Model] KTC-(50mm-1250mm) lever type [Measurement stroke] 50mm-1250mm [Repeat accuracy] 0.05mm [Protection level] IP67 IP54 IP57 [Application] Injection molding machine, die casting machine, blowing machine, shoe making machine, printing machine, woodworking machinery, cable machinery, linear displacement equipment, rotary cutting machine, planer automation control equipment and other fields. Can’t connect the wrong three lines The “1” and “3” lines are power lines, and the “2” is the output line. Except that the power line (“1”, “3” line) can be exchanged, the “2” line can only be the output line. Once the above-mentioned lines are connected incorrectly, linear errors will occur, control is very difficult, control precision is poor, and jumping is easy to display. Installation is better for neutral The angle allows ±12° error, and the parallelism allows ±0.5mm. If the angle error and the parallelism error are both too large, the display digital jump will be caused. In this case, be sure to adjust the angle and parallelism. Prevent short circuit During the operation of the displacement sensor electronic ruler, the data is displayed at a certain point or not, and the data is skipped or not displayed. In this case, it is necessary to check whether the insulation of the connection line is damaged and a short circuit to the ground caused by regular contact with the metal casing of the machine. Avoid aging Note: For the electronic ruler which has been used for a long time, the seal is aging, there may be many impurities, and there is a mixture of oil and water, which affects the contact resistance of the brush, which causes the display to jump. It can be considered as the early damage of the displacement sensor electronic scale itself. If the electronic ruler has been used for a long time, and the seal has deteriorated, and there are many impurities, and the water mixture and oil will seriously affect the contact resistance of the brush, the number of the display will keep jumping. At this time, it can be said that the electronic scale of the linear displacement sensor has been damaged and needs to be replaced. KTC is a general-purpose type suitable for position detection of various types of equipment. Such as: injection molding machine, die casting machine, rubber machine, shoe machine, EVA injection machine, woodworking machinery, hydraulic machinery, etc. KTF is a general-purpose installation miniaturization, especially suitable for reducing the installation length of the mechanical length direction, suitable for large stroke applications. Such as: large injection molding machine clamping stroke, rubber machine clamping stroke, woodworking machinery, hydraulic machinery. KTM is a series of miniature drawbars, especially suitable for applications with small space, such as: aircraft steering, ship steering, shoemaking machinery (front helper, rear helper), thimble position control of injection molding machine, printing machinery, paper packaging machinery. KTR is a miniature self-recovery type, which is especially suitable for occasions where space is limited and inconvenient to install. Such as: vacuum bottle blowing machine, IT equipment, tension adjustment, speed adjustment, printing machinery, paper packaging machinery.